General Electric Washer WNSB8060B0WW Timer Repair

What is the timer/clock part number for the General Electric WNSB8060B0WW Washer?

Timer part number WH12X10138 for General Electric WNSB8060B0WW

The WNSB8060B0WW Washer uses timer part number WH12X10138.

Do you have a failed General Electric WNSB8060B0WW control panel? Click here:

We can repair or replace your faulty General Electric WNSB8060B0WW timer.

WNSB8060B0WW are also sometimes referred to using these Alternative Names/Model numbers

GE WNSB8060B0WW Washer

WNSB8060B0WW Schematic and Wiring Diagrams

Controls & backsplash Parts diagram

Cabinet, cover & front panel Parts diagram

Tub, basket & agitator Parts diagram

Suspension, pump & drive components Parts diagram

Recent Service Requests

City	Problem Description	Resolution
hudson, New York	After tub fill with water it's don't washing (thumble), But it's speen and drain water.	Awaiting receipt of timer

Common problems for General Electric Washer WNSB8060B0WW Timer Repair

Are you encountering a similar problem as them? Contact us now and we will try to help you fix your WNSB8060B0WW timer-related problem.

I have a LG combo washer/dryer. The dryer portion in leaves the clothes soak and wet when drying cycle is done. I cleaned the container that clogs up with lint. The heating element gets very hot. But still no drying. Anyone have any ideas?

This microwave is slightly over 1 year old and everything works fine except it will not heat food. clock counts down, turntable turns, etc but will not heat. Any help on what the problem could be?

When I use the microwave, it does not heat, not does the light turn on, the clock does count down, and makes a clicking noise. It died last year at less than one year old, and the magnetron was replaced.

I replaced the Control Panel Asy. (Part# W10210864) and Microcomputer (Part# W10211457) to repair my microwave's F6 error Code and still get an F6 Code. My problem started when I noticed the Control Panel's outer box was not aligned with the oven's door (It was slightly higher). I tried to push it down and it wouldn't bulge, so I placed a board on its upper edge and tried to move it down by hammering the piece. When I connected the oven it read F6- Call for Service. After I replaced the two parts noted above, I connected the oven and the screen said to program the clock. I set the clock, closed the oven's door and the screen once again read F6. Any ideas or comments? Yes, I know, I shouldn't use a hammer to fix a microwave.

I have a GE washing machine WNSB8060B0WW. The tub will not spin. It starts to spin and then it makes a clicking noise and the it stops. It starts to spin for about 10 seconds. What is wrong.