Magic Chef 9475XVB Timer

What is the timer/clock part number for the Magic Chef 9475XVB Range?

Timer part number 10682386KF for Magic Chef 9475XVB

The 9475XVB Range uses timer part number 10682386KF.

Do you have a failed Magic Chef 9475XVB control panel? Click here:

Request Appliance Timer Service

We can repair or replace your faulty Magic Chef 9475XVB timer.

9475XVB are also sometimes referred to using these Alternative Names/Model numbers

Maytag 9475XVB Range, Whirlpool 9475XVB Range

9475XVB Schematic and Wiring Diagrams

Control panel Parts diagram
9475XVB Range Control panel Parts diagram
Internal controls Parts diagram
9475XVB Range Internal controls Parts diagram
Body Parts diagram
9475XVB Range Body Parts diagram
Door Parts diagram
9475XVB Range Door Parts diagram
Gas controls Parts diagram
9475XVB Range Gas controls Parts diagram
Door (ser. pre. 14) Parts diagram
9475XVB Range Door (ser. pre. 14) Parts diagram

Recent Service Requests

CityManufacturerModel NumberPart NumberFailure CodeProblem DescriptionResolution
Champlain, QuébecMagic Chef9475XVB7601P232-60F2Even if you set the oven at any degres 200-300-400-or what ever the heat never sotp to go up look's like went the thermostat is satisfy and give the signal to the control panel to stop the control panel keep on going up and never stop.Beyond Repair
Gaston, IndianaMagic Chef9475XVB/10682386Kf7601P232-60100-00643-00585/905N/AJust doesn't work.

If timer can not be repaired, please e-mail us with pricing for a new one and shipping options. We'll respond ASAP
Timer inspected, no repairs necessary
Tecumseh, OntarioMagic Chef9475XVB7601P232-60F-5works for a 1 minute or so than shuts off and displays error code F-5Repaired
Austin, TexasMagic Chef9475XVB7601P232-60N/ADisplay is burned out.Replaced with reconditioned timer
Potomac, MarylandMagic Chef9475XVB7601P239-60F5Code F5 comes on and oven will not start.Beyond Repair
West Fork, ArkansasMagic Chef9475XVB7601P232-60u/kOven ignitor not coming on. New ignitor. An appliance tech told me a prior sloppy ignitor repair had caused the motherboard to be fried. Broil ignitor glows bright and broil burner comes on.Awaiting receipt of timer
katy, TexasMagic Chef9475XVB10682386KF5IT SHOWS F5 CODE AND NOT BAKEAwaiting receipt of timer
Wheatley, OntarioMagic Chef9475XVB7601P232-60F5Igniters are intermittently working and when not working I get an F5 code.Awaiting receipt of timer
Austin, TexasMagic Chef9475XVB7601P232-60none - blank screenblank and unresponsive screenAwaiting receipt of timer
peace river, AlbertaMagic Chef9475XVBEAP132124N/Adisplay does not show anything. oven will turn on and off by hitting bake button but no display. no clock display.Repaired
Wheatley, OntarioMagic Chef9475XVBunknownF5Problem was intermittent but is now seemingly permanent as code pops up every time we attempt to use it, resulting in no source of ignition.Repaired
Waleska, GeorgiaMagic Chef9475XVB7601P232-60F7works intermittentlyAwaiting receipt of timer
San Clemente, CaliforniaMagic Chef9475XVB7601P232-60F5F5 code and shuts offAwaiting receipt of timer
Valley City, OhioMagic Chef9475XVB7601P232-60No CodeUnit is completely dead. No clock in the window, buttons do not activate anything. If this can't be repaired, I would like a refurbished unit if one is available.Repaired
Stoney Creek, OntarioMagic Chef9475XVB7601P232-60F5Oven starts normally and after about one minute it shuts down, starts beeping and displays F-5. Pressing the Stop/Clear button turns the display and beeping off.
Problem started 5 +/- years ago maybe once a year but oven would work fine the next day for the year or more. The oven will not fire up at all now.
Repaired

Common problems for Magic Chef 9475XVB Timer

Are you encountering a similar problem as them? Contact us now and we will try to help you fix your 9475XVB timer-related problem.
Yesterday, when I was doing my first load of laundry, I started my washer the usual way, selecting the water level, water temperature and the wash cycle. When I attempted to pull the cycle selector control buttom out to start the water filling into the washer basket, it came out only with a trickle. I pushed the wash selector button in and went to another wash cycle and the water started flowing in with the usual appropriate flow and quickly filled up the the appropriate level and completed the wash cycle. However, when I attempted to wash a second load, the same thing happened - and switching to another wash selector did not correct the problem. I pushed the wash cycle selector button in and waited for (5) five minutes and tried again. The water came in with the regular flow and went through the complete cycle. This has happened several times before - at the rinse cycle, the water trickling in slowly and not filling to the appropiate level for the washing cycle to continue - with me g
I have a hand-me-down washer from my parents when I moved into my house 4 years ago. I was changing the settings on the knob, and then all of the sudden the machine would not start. So, I checked the outlet by plugging in my sweeper, and the outlet worked. I also checked the breaker box, and nothing blew there. So, I pulled off the front control panel, and noticed a little fuse that was blown. So, I replaced the fuse, and it blew again right away. SO, I have no idea what to do next? I can supply pictures of anything if needed.. I just need help!! Please Todd
I am trying to replace the trigger used to start wash cycle when lid is closed. I am having problems getting to, reaching, and unscrewing the bolt that the ground wire is connected to. What method should I use to unscew the ground wire? primetime22
Getting an F-1 code. The code schedule solution says to replace the touch pad or clock. I can not ID a touch pad from the control panel module drawing. There is no p/n for a touch pad. I hesitate to disassemble the oven until I have the repair parts on hand. Anyone had this module apart or had any experience with the clock and face plate assembly?
I would like to confirm that the clock is in fact the problem with my dishwasher. When last set going it ran for 3 1/2 hours without the dial moving into the rinse cycle. It opened the soap dispenser but there was no water (or very little) to wash it away as the soap was (and still is) stuck in place. The clock stuck at the end of the wash cycle after the water had run out. Got extremely hot and kept attempting to run with no water in it. Is this a clock problem (no matter what the model # is)? Whirlpool part #AP4112921.
Washer is almost "dead". Motor is not working in any mode. If washer is plugged in it could be filled with water. If it is not plugged in water is not coming in. In any case the motor is not working. Is there a fuse on that model? I do not have a manual.
So my magic chef oven - model #9475XVB - will not let me do anything right now. I turned off power at the circuit breaker for a few minutes and this did notwork. The screen says "door" and it is not blinking. I think one of the eight young kids in the house moved the cleaning lever lock mechanism to the right while grandma was baking cookies. What can I do to reset the oven so I can make homemade pizzas for the 8 kids and 6 adults in the house this evening? No service tech. is available out here where I live for at least a week and a half. . .
I have a Magic Chef gas wall oven that doesn't light properly. I've had the clock rebuilt and replaced the bottom termocouple which I thought may have to much resistance because the bottom burner doesn't light even though the termocouple was red, but still on success. Here's what happens; 1] on bake the bottom termocouple gets white hot, the top doesn't get red, and no light. 2] on briol the top termocouple gets white and lights. normal 3] on clean the top burner lights but the bottom doesn't. What should I try next? could it be the safty valve, or do I still have a problem with the time. Does the maytag 7601p232-60 clock give an error code. Thanks, Richard

How people are finding this page

  • magic chef stove parts diagram
  • magic chef 9475xvb
  • 7601P232-60
  • 9475xvb
  • magic chef # 9475 XVB timer
  • magic chef MODELO # 9475 XVB
  • magic chef model number 9475xvb
  • magic chef stove repair manual
  • washing machine components diagram
  • washing machine control bottum
  • 9475xvb wiring diagram
  • MAGIC CHEF 9475 XRS CONTROL BOARD WIRING DIAGRAM
  • Magic Chef stove control panel doesn't light up
  • Magic Chef washing machine timer
  • appliance repairs in quebec that does magic chefs control mudule repairs
  • curcuit board for magic chef oven model # 9475xvb
  • homemade manual sweeper
  • how to get face plate off timer on magic chef washer
  • 14 parts
  • magic chef 7601p232-60
  • magic chef timesaver range display out
  • magic chef 9475xvb does not heat
  • magic chef 9475xvb wiring diagram
  • oven control boardfor magic chef oven model # 9475xvb
  • magic chef cost for clock module
  • magic chef model 9475XVB
  • model 9475xvb
  • magic chef parts oven 9475xvb
  • magic chef stove oven control panel module
  • magic chef wall oven 9475xvb parts
  • magic chef touch panel doesn't change time
  • magic chef time saver range f5
  • 9475XVB Range faulty erc
  • 9475XVB Range faulty panel
  • timers for 9475XVB Range
  • Magic Chef 9475XVB timer
  • 9475XVB relay
  • 9475XVB Range replacement timer
  • relay for 9475XVB Range
  • 9475XVB Range replacement erc
  • 9475XVB Range control
  • 9475XVB Range failed module
  • 9475XVB Range relay
  • 9475XVB Range faulty module
  • 9475XVB clock
  • 9475XVB Range replacement panel
  • 9475XVB Range timer repair
  • 9475XVB Range failed timers
  • 9475XVB erc
  • 9475XVB Range assembly
  • Magic Chef 9475XVB boards
  • 9475XVB Range controls
  • 9475XVB Range clock
  • 9475XVB Range panel
  • 9475XVB clock/timer
  • Magic Chef 9475XVB timers
  • 9475XVB Range controller repair
  • 9475XVB Range timers
  • 9475XVB Range failed clock/timer
  • 9475XVB display
  • 9475XVB Range faulty sensor
  • 9475XVB control
  • sensor for 9475XVB Range
  • 9475XVB Range replacement display
  • 9475XVB Range panel repair
  • 9475XVB Range faulty controller
  • 9475XVB Range failed boards
  • 9475XVB Range failed panel
  • display for 9475XVB Range
  • timer for 9475XVB Range
  • 9475XVB Range replacement assembly
  • 9475XVB Range controller