Frigidaire GLDB958AB2 Timer Repair

My problem in a limited or reduced water flow to the upper spray arm. I have removed the filter and impeller covers as well as the check ball and checked for obstructions. I have removed the upper spray arm supply hose as well as the spray head nozzle assembly. I have added extra water, since the level at the end of fill seemed a little low. None of this improved the flow. Have pulled the machine away for the cabinet and can observe the water flow going up the clear feed tube for the spray head. There is not enough volume to make the spray arm work. The pump impeller appears to be in good shape (Not loose or broken). Any suggestions??

I just installed a new GE dishwasher. It was the floor model, don't know if that's why I'm having problems Leaks from front left bottom of door. Went back to look at another one and the seal has a crease in it from where the door contacts it. Mine doesn't do that so I think that door needs to be adjusted more tighter against the seal. How do I do that?

My dishwasher starts fine goes through the 1st wash cycle then does nothing. The water is standing in the bottom of the dishwasher, in order to remove the water I have to cancel the wash. So in other word it drains when I cancel the wash but not during the wash cycle.

thought that it was the clock, replaced it . still have the problem. it runs through the whole washing cycle up to the drying cycle and then it doesnt go any farther, unless i turn it manually. otherwise it will run for hours at that point.

everything looks normal you can select any cycle you like, and the clock for the cycle shows the proper run cycle but soon as you press start the cycle switches to china crystal and you can't change it. Tried to reset and turned off breaker for 2 minutes but problem persists any ideas

have a dishwasher gldb958ab2 that flash h.o. after 15 min run time can you help?