|Waynesboro, Tennessee||Kenmore||911.4832990||ERC-14500-RP||F1||Went away for a few days and to conserve electric we turned the heat down to 55F. When we came back oven was beeping and flashing F1 & would not clear. Do you think having it cool and damp in the home made it go out? Also, when mailing back, just mail it back cheapest way possible, not in a huge hurry for it, but of course would like for you to repair it as soon as possible as well though. I didn't know exact what to click on for return shipping so I thought I would just write it here...||Beyond Repair|
|Kings Mountain, North Carolina||GE||ERC-14500-RP||F1||F1 came on and beeped. Tried to reset timer by using clear off button but continued to have failure. Turned off main power for few hours, turned power back on and after one minute the F1 alarm came on and could not reset.||Beyond Repair|
|Pearland, Texas||GE||ERC 14500 - RP||none||Oven does not heat to proper tempature. Checked sensor and it read approx 1100 ohms at control panel per tech sheet in oven. Clean cycle works correctly.|
Too low temp, preheats too quickly to wrong temp although read out says it is to desired temp.
I would like control from inventory if available.
|Awaiting receipt of timer|
|Round Rock, Texas||General Electric||JKP13G0P4BG||ERC-14500-RP||F1||Beeps, displays F1, and fault will not reset.||Awaiting receipt of timer|
|Falls Church, Virginia||General Electric||JRP14||ERC-14500-RP||F1||F1 fault with beep - persistent.||Beyond Repair|
|Elm Grove, Louisiana||Kenmore||9114742593||ERC-14500-RP||F-1||Stove/oven will power up then start beeping and displaying code F-1||Beyond Repair|
|Allen, Texas||General Electric||JKP13GOT1BB||ERC 14500-RP||NONE||Oven fails to heat to temperature set on timer. Replaced probe.||Awaiting receipt of timer|
|Allen, Texas||General Electric||jkp13got1bb||erc 14500-rp||None||Oven does not heat to control setting. Replaced temperature probe.||Repaired|
|Natchez, Mississippi||Kenmore||911.9359181||erc-14500-rp||N/A||the timer is dead. no read out!!||Beyond Repair|
|Lawrence, Kansas||Kenmore||911.4042990||ERC-14500-RP||F1?||The customer says he gets an error code occasionally, I believe it was F1, but not positive. (tech couldn't remember) Tech sheet said the error meant to replace ERC. Sears lists the part number RFR-CGI, and my distributor lists the part number as 343439. The part numer I listed above is what is on the timer itself (ERC-14500-RP).||Beyond Repair|
|Allen, Texas||General Electric||jkp13got1bb||erc 14500-rp||None||Oven does not heat to ERC setting. Replaced temperature probe.||Repaired|
|AMHERST, New Hampshire||Kenmore||911-4012190||ERC-14500-RP||F-1||REPAIR OR EVEN PIRCHASE REFURBISHED IF AVIALBLE.||Awaiting receipt of timer|
|Kuna, Idaho||Sears||911 9352191||ERC14500-RP||N/A||Oven temp starts out at 350 degress and beeps,only turns on element if set to 450 to 500 degrees. Checked oven temp senosr and it measures 1100 ohm"s cold and is in spec as per wiring diagram.||Repaired|
|Akron, Ohio||Kenmore||911.95999181||erc-14500-rp||none||Oven will turn on but before heating the oven shuts off. No error code just shuts off. If you try to start again you'll hear a noise like it's shorting out then shuts down.||Beyond Repair|
|Plano, Texas||General Electric||JKP14WP3WG||ERC-14500-RP||F1||Error F1 flashes and timer beeps. Error persists when touch pad is disconnected.||Awaiting receipt of timer|
|Hixson, Tennessee||Kenmore||911.4012190||ERC-14500-RP||none||Oven temp is too low, approx 150F less than setting. Indicates preheated too soon and temp is too low. Temp sensor verified good. No failure codes are indicated.||Repaired|
|Cape May Court House, New Jersey||Kenmore||9117359180||ERC-14500-RP||F1||Turn oven to bake and buzzing sound followed by code F1||Awaiting receipt of timer|
|charleston, West Virginia||Sears||95999||erc-14500-rp||n/a||up and down arrow buttons do not work. cannot make any number settings on timer, clock or temp.||Repaired|
|Sikeston, Missouri||Kenmore||911 4132993||ERC-14500-RP||F1||Not sure what you mean by problem is intermittent.||Repaired|
|Evans, Georgia||General Electric||JKP14WOP3WG||ERC-14500-RP||none||Will not reach temperature. Controller reads target temp, and acknowledges temp. Oven will not reach more than 300 degrees||Awaiting receipt of timer|
|Mt Airy, Maryland||General Electric||ERC-14500-RP||none||Does not heat. No error codes. Will not self clean. Checked thermo sensor and is correct ohms at room temp.||Repaired|
|Imperial, Missouri||Kenmore||911.9369181||ERC-14500-RP||Unknown||When we turn on the oven, it starts to heat up an then turns off after about 3 minutes. The broiler did the same. The burners all work fine. We replaced the temperature probe on teh oven, but it continued to operate the same - start to heat up and then turn off.||Repaired|
|Williston, Vermont||General Electric||GE walloven||ERC14500RP||F1||Please send unit to the "SHIPPING" address.|
Please include in the box my home shipping address that I originally sent you.
Jim Saltsman, 16 Currier St, Barre, VT 05641
Thank you for your help with this.
|collierville, Tennessee||General Electric||jkp26gop4bg||erc-14500-rp||f1||f1 code and constant beeping.||Awaiting receipt of timer|
|Lawrenceville, Georgia||General Electric||JKP14W0TWW||ERC-14500-RP||F2 and F3||Sometimes it works but it will sometimes fail usually during the warmup period nearing 400 degrees with F2 or F3 accompanied by beeping.||Repaired|